Astroprint & Raspberry Pi 3

AstroPrint & Raspberry Pi 3 Support

If you are looking for instructions on How to build your own Astrobox with a Raspberry Pi 3, follow this guide.

AstroPrint currently supports Raspberry Pi 3, but there ARE some caveats, namely: You will need an additional WiFi dongle along with the Raspberry Pi 3’s built-in WiFi.

Why exactly do I need another WiFi dongle when the Raspberry Pi 3 has built in WiFi?

The built-in WiFi on the Raspberry Pi 3 cannot maintain a simultaneous network connection to your WiFi network and broadcast it’s own hotspot like we require on our Astroboxes. Therefore, the built-in Raspberry Pi 3 WiFi is not sufficient for our purposes at this time.

In order to circumvent this, you will need an additional WiFi dongle to make an Astrobox using a Raspberry Pi 3 board.

With that said, the built in Raspberry Pi 3 WiFi is still used.

The need for the additional WiFi dongle is mainly to support hotspot functionality.

Note: If you don’t need hotspot functionality, it is possible to use a Raspberry Pi 3 without a WiFi dongle. You’ll need to be aware of the Astrobox’s IP address while you set it up for the first time using ethernet, though.

If you have any questions or suggestions about any of the above, join us on our forums.

Share: Share on FacebookTweet about this on Twitter